This braking resistor allows your drive to operate while braking to a standstill or during slowdown braking. It dissipates the braking energy, and enables maximum transient braking torque. It has an Ohmic value of 15Ohms at 20°C and its protection index is IP20. It is compatible with Altivar 312, Altivar 61, Altivar 71, Lexium 32 / 32i and lexium 52.
braking resistor, Altivar, IP20, 15Ohm, 1000W
braking resistor, Altivar, IP20, 15Ohm, 1000W
SKU: 515173
Category: Motion Control
Reviews (0)
Be the first to review “braking resistor, Altivar, IP20, 15Ohm, 1000W” Cancel reply
Related products
Incremental encoder Ø 58 – through shaft 14 mm – 1024 points – push-pull
Incremental encoder Ø 58 - through shaft 14 mm - 1024 points - push-pull
integrated drive ILS with stepper motor- 24..36V-pulse/direction w/o RS422- 3.5A
integrated drive ILS with stepper motor- 24..36V-pulse/direction w/o RS422- 3.5A
Preassembled cord set for RS422 interface – for LXM05 – 5 m
Preassembled cord set for RS422 interface - for LXM05 - 5 m
Absolute encoder Ø 90 single turn – through shaft 30 mm – push-pull 13-bit Gray
Absolute encoder Ø 90 single turn - through shaft 30 mm - push-pull 13-bit Gray
Ethernet TCP/IP managed switch – ConneXium – 7TX/1FX – multimode
Ethernet TCP/IP managed switch - ConneXium - 7TX/1FX - multimode
pre-assembled cable kit – I/O for motion sequence – 3 m
pre-assembled cable kit - I/O for motion sequence - 3 m
connecting cable, Lexium SD3, for pulse or direction signal, 5V, 1.5m, for TSX CFY
connecting cable, Lexium SD3, for pulse or direction signal, 5V, 1.5m, for TSX CFY

Reviews
There are no reviews yet.